Fishing Victoria Forum

:fish22:

purple5ive wrote:

smile0784 wrote:

purple5ive wrote:ok,
i would be carefull blowing into the handle brackets. you can actually push grit into the main bearings. its happened to me before. but if its working for you then i guess all good.

Washing the reel first should get rid of the any sand and grit

not if its already inside the handle cavity mate

Well dont drop it then lol

smokin_reels wrote:http://www.inoxmx.com/inox-mx3-for-fishing/

This stuff. Can’t rate it high enough

I use it on all my electrics as well.... I also use the MX4 on the trailer (http://www.inoxmx.com/inox/mx4-lubricant/) and MX8 on the bearings (http://www.inoxmx.com/inox/mx8-high-temp-grease/)

Mattblack wrote:

smokin_reels wrote:http://www.inoxmx.com/inox-mx3-for-fishing/

This stuff. Can’t rate it high enough

I use it on all my electrics as well.... I also use the MX4 on the trailer (http://www.inoxmx.com/inox/mx4-lubricant/) and MX8 on the bearings (http://www.inoxmx.com/inox/mx8-high-temp-grease/)

What is the heat rating on the inox if using on the bearings

smile0784 wrote:

Mattblack wrote:

smokin_reels wrote:http://www.inoxmx.com/inox-mx3-for-fishing/

This stuff. Can’t rate it high enough

I use it on all my electrics as well.... I also use the MX4 on the trailer (http://www.inoxmx.com/inox/mx4-lubricant/) and MX8 on the bearings (http://www.inoxmx.com/inox/mx8-high-temp-grease/)

What is the heat rating on the inox if using on the bearings

Just off the top of my head I'd say MX8 has a dropping point of 260 degrees celcius. Depending on the application MX8 will perform at 200 degrees celcius and take spikes of up to 220 degrees celcius.

Mattblack wrote:

smile0784 wrote:

Mattblack wrote:

smokin_reels wrote:http://www.inoxmx.com/inox-mx3-for-fishing/

This stuff. Can’t rate it high enough

I use it on all my electrics as well.... I also use the MX4 on the trailer (http://www.inoxmx.com/inox/mx4-lubricant/) and MX8 on the bearings (http://www.inoxmx.com/inox/mx8-high-temp-grease/)

What is the heat rating on the inox if using on the bearings

Just off the top of my head I'd say MX8 has a dropping point of 260 degrees celcius. Depending on the application MX8 will perform at 200 degrees celcius and take spikes of up to 220 degrees celcius.

Ill try it out on my bearings